VUGERA POWER OBD-II

Posted by DASHCAMSPECIALISTS admin on

Super Safe & Easy dashcam installation with VUGERA POWER OBD-II
VUGERA Safe
Clean install and Super Safe Operation
No need to waste time searching for B+ and ACC fuse
Concerned of Manufacturer Warranty Void?
Plug & Play Easy (no hard-wiring or modification required)
-VUGERA dashcam dedicated cable for vehicle protection with over-current cut-off circuit
-Switchable recording mode (Driving only or Driving and Parking mode)
-Built-in G-sensor for wake-up on vehicle impact even when dashcam is switched OFF
-Enters parking mode when engine ignition is switched OFF (5 mins)
-Automatic cut-off at 11.8V (overrides lower voltage cut-off settings)
-Applicable on vehicles that are equipped with a universal OBD-2 port
Emergency Wake-up Feature (when Parking Mode is switched OFF)
In the event of a severe impact detected by the OBD, VUGERA will wake-up even when the Parking Mode is selected ‘OFF’ and record for 2 mins and then switch OFF by itself

Share this post



← Older Post Newer Post →